CEB Press/User's Manual/Testing

1 Tools

2 Computer

2 USB Cable

2 CEB Press

1 Steps

2 Upload the CEB Testing Code

http://opensourceecology.org/wiki/CEB_Press/Manufacturing_Instructions/Code_Upload

2 Run the CEB Testing Python Code

2 Within the CEB Testing Python GUI (Graphical User Interface), click "open connection". If connection is not established, check that the port name in the Arduino IDE Tools>Serial Port matches the port name within the CEB Testing Code near the beginning.

2 GUI Testing Instructions - Make sure not to jam the cylinder movements.

3

MOSFET 3 = Primary Cylinder Down

MOSFET 6 = Primary Cylinder Up

MOSFET 9 = Secondary Cylinder Left

MOSFET 10 = Secondary Cylinder Right

MOSFET 11 = Shaker Spin

LED = Arduino LED

Sensor = All Sensors Are Read at Medium Frequency (check Arduino IDE serial monitor for the observed analog values)

2 Toggle off the controller box to stop the CEB Press electronic influence on the hydraulic system (all solenoids return to open center, all work ports offline).