Electronics Workstation

ESD (Electro-static discharge) Protection

• ESD Mat Source In Testing

• ESD Wriststrap Source In Testing

• ESD Smock [Source]

• Conformal Coating [Source]

Power

• CSI3005x5: Benchtop Power Supply Source

Soldering

• Hakko FX 888: Soldering Station Source

• Solder [Source]

• Flux [Source

Thermal Transfer

• Wagner HT1000: 1200W Heat Gun Source

Air Safety

• Carbon Filters Source

• Fan Source

• 12V Power Supply Source

Signal Analysis

• Oscilloscope Source

Connection and Insulation

• Shrink Tubing Source

• Connectors

• Fuses Source

• Light Duty Switch Source

• Emergency Switch [Source]

Discrete Electrical Components

• Resistors Source

• Capacitors Source

Holders

• Helping Hands with Magnifier Source

Battery Charging

• NiMH: Set power supply at 1.2V with current limit depending on the battery's capacity (ex. if 2500mAh, then set current limit at 2.5A). For multiple batteries, connect the batteries in parallel then set the current limit based on the battery set's capacity (ex. if 30,000mAh, then set current limit at 30A). Lower current limits are ok, but they will result in slower charge rates; higher current limits are situationally ok- if excessive current is channeled for too long a time, then the battery will overheat.