LifeTrac II Part Sourcing

Swaiger

• 4 × 8'×4"×4" tubes for base.
• 3 × 5'×4"×4" under base tubes.
• 12 × 10"×8"×0.5" steel plates to mount flange bearings and hydraulic motors to.
• 4 × 28"×1-7/8" axle shafts
• 2 × 56"×4"×4" vertical chassie centre tubes
• 4 × 59"×4"×4" vertical chassie 4 corner tubes
• 2 × 88"×4"×4" top chassie tubes
• 3 × 44"×4"×4" top chassie tubes
• 4 × 54"1-7/8" loader shafts
• 2 × 100"×6"×2" front loader arm tubes
• 2 × 84"×6"×2" rear loader arm tubes
• 4 × 10"×8"×1/2" or 3/8" plate to mount h/cylinders to base

• 12 × 8"dom to mount loader shafts to loader arms.
• 1"bore tubing for 8 bushings to connect h/cylinders to loaders
• plate to mount bushings to loader arms

• 4 × 32"diameter×9" wheels
• 1/2"plate & 1-15/16"tubing to make wheel mounts

• 76 × 6"×3/4" bolts & nuts & washers to suit

Surplus Centre

• 8 × flange Bearings - [1]
• 2 × Front Loader cylinders - 36" - $174 - 48 5/8" retracted length - [2]
• 2 × Rear loader cylinders
• 4 × Motors - [3]
• 4 × 1-1/4" shaft couplers - [4]
• 1-3/8" 6T fully splined shafting - [5]
• 16 × 1.875" double split shaft collars - [6]