D3D Ohio 18.20 Calculations

From Open Source Ecology
Jump to navigation Jump to search


These are bounds and other calculations for the D3D Ohio printer

Extruder boundry calculations

X plus X plus bounds

X Minux X minus bounds

Y plus Y plus bounds

Y minus Y minus bounds

PVC frame rendering calculations

the pvc frame is generated by adding the length of an axis plus the diameter of two pipe thicknesses. this initial version uses one inch pipes, so that was added to either end.

The rod length of all axis was 500mm. The outer diameter of a 1" sch 40 pipe is 1.31" so, our length for each axis of the frame was 533.5mm

The PVC pipes generated length was 493.546mm; which could be approximated for a cut length of 493.5mm.

During assembly, a slightly (order of a few mm) pipe cut will allow for during cementing the fitting to be "snugged" around the axis it is accommodating.