CEB Press/Manufacturing Instructions/Roller guides

Main > Housing and construction > CEB Press > CEB press building instructions

Tools Required

• Hole punch or drill with 1/2” bit
• Welder
• Angle Grinder

Materials Required

You need 2 roller guides. Each one requires the following:

Steel:

• 1/2”x3”x12” plate (1)
• Spacer plate (1) (One roller guide will use a 3/8" thick plate, and the other will use a 1/2" plate)(these can be scrap, but need to be smaller than 3”x9.5”)

Bolts:

• 1/2”x2” bolt (1)
• 12mm x 50mm bolts (2)

Nuts:

• 1/2” nut (1)
• 12mm nuts (2)

Washers:

• 1/2” washer (1)
• 1/2” lock washer (1)
• 12mm lock washers (4)

Bearings:

• V Groove bearing 12mm Buy

Fabrication Steps

punch 1/2" holes:

• • 3/8”x2”x8.5” (2) – 3” sep at center
  • 1/2”x2”x3.5” (2) – 1” off end
  • 1/2”x2”x4 3/4” (2) – 1” off end