Cold Saw/Build Instructions

Steps

• Lathe the Base Disc. Measure, mark, and pilot drill the Base Disc.

• Match pilot drill the Base Plate through the Base Disc.

• Match pilot drill the Fixed Block through the Base Disc.

• Drill the Base Plate.

• Drill the Fixed Block mount holes. Measure, mark, pilot drill, and drill the axis holes on the Fixed Block.

Vise Assembly

• Clamp Blocks onto Moving Blocks: Tack weld + weld the Clamp Blocks onto the Moving Blocks, then surface grind the clamping face of the Clamp Blocks such that their clamping faces are parallel. Then drill the Jaw holes through the Clamp Blocks.

• Threaded Rod and Nuts: Position the Moving Block such that the Threaded Rod can be inserted vertically. Insert the Threaded Rod, then fasten the Nut onto the threaded rod such that the nut contacts the Moving Block. Center the nut approximately then tack weld + weld the nut onto the Moving Block.