Backhoe Boom Test Driven Design: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Based on Backhoe Boom Range of Motion Analysis, the procedure is: #Mount a 2x4 hole standard bonding plate with 4 holes showing at top of boom. #Mount") |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 2: | Line 2: | ||
#Mount a 2x4 hole standard bonding plate with 4 holes showing at top of boom. | #Mount a 2x4 hole standard bonding plate with 4 holes showing at top of boom. | ||
# | #Bolt plate using 2 holes only so mount point is 10" above tubing | ||
#Weld assist for proper hold | |||
Done. Now to stick. See [[File:BoomROM.dxf]] for [[Test-Driven Design]] that was used. | |||
Latest revision as of 22:59, 21 October 2013
Based on Backhoe Boom Range of Motion Analysis, the procedure is:
- Mount a 2x4 hole standard bonding plate with 4 holes showing at top of boom.
- Bolt plate using 2 holes only so mount point is 10" above tubing
- Weld assist for proper hold
Done. Now to stick. See File:BoomROM.dxf for Test-Driven Design that was used.