Brick Pressing Rate Calculations: Difference between revisions
| Line 41: | Line 41: | ||
For 2" pavers, or thin bricks used in floors - the result is 20 bricks per mintute. Assuming 10% extra time as above, the final '''pressing rate for 2" pavers is 18 bricks per minute'''. | For 2" pavers, or thin bricks used in floors - the result is 20 bricks per mintute. Assuming 10% extra time as above, the final '''pressing rate for 2" pavers is 18 bricks per minute'''. | ||
=Update= | |||
For The Liberator II | |||
[[Category:CEB Press]] | [[Category:CEB Press]] | ||
Revision as of 19:55, 25 January 2010
Introduction
Under the assumption of incompressible flow and fixed hydrauilic cylinder volume, the brick pressing rate of The Liberator can be calculated for a given hydraulic flow rate.
The Liberator
The Liberator uses a 5x8x2 inch cylinder (diameter x length x rod diameter) for pressing, and a 2.5x14x1.125" cylinder for the soil loading drawer.
The effective volumes for both cylinders differ. This is because the cylinder rod takes up some volume - thereby reducing effective volume and force for the contraction part of the stroke. The expansion part of the stroke uses the full cylinder volume.
Main Cylinder Volume, D= 5 inches, D_rod=2 inches
- Cylinder volume (expansion volume) = 157 cu in
- Rod volume = 25 cu in
- Cylinder volume-rod volume (contraction volume) = 132 cu in
- Volume filled for a complete cycle of the cylinder (expansion volume + contraction volume) = 289 cu in
Secondary Cylinder Volume, d=2.5 inches, d_rod=1.125 inches
- Cylinder volume (expansion volume) = 69 cu in
- Rod volume = 14 cu in
- Cylinder volume-rod volume (contraction volume) = 55 cu in
- Volume filled for a complete cycle of the cylinder (expansion volume + contraction volume) = 124 cu in
One complete cycle volume
One cycle volume = 413 cu in
1 gallon = 231 cu in
1 cycle = 1.8 gallons of fluid
Pressing Rate Results
Here we onsider the pressing of 4, 3, and 2 inch tall bricks. Thus, brick dimensions are (2-4)x6x12 inches.
Assuming 24 gallons per minute are available, this translates to 13 bricks per minute. Assume that compression requires 10% extra time because of operation under compression load for a small part of the pressing cycle - and you have 12 bricks per minute for full, 4" thick bricks.
Assume that for example 3" tall bricks are desired. These can be produced with 6 inches of main cylinder motion, or 3/4 of the full cycle volume, or 216 cu in. The cycle total is thus 341 cu in, or 1 cycle = 1.5 gallons. This constitutes 16 bricks per minute. Asume 10% extra time as above, and the final result is 14 bricks per minute for 3" tall bricks.
For 2" pavers, or thin bricks used in floors - the result is 20 bricks per mintute. Assuming 10% extra time as above, the final pressing rate for 2" pavers is 18 bricks per minute.
Update
For The Liberator II