Revision as of 00:49, 4 September 2014

Requirement

Test-driven Contract-First Requirement - flat surface for meeting with other wall or brick sections
Detachable with exposed fasteners that can be accessed for deconstruction
Caulked at right angle seams if necessary
Fully insulated air tight when joining adjacent panels
Allow for slanted sections under roof
Uses R19 fiberglass batts - ex [1]
Uses 2"x6" lumber, integrating with 2"x6" being used for all other structural components.
Layers 2 framed sections to achieve any width necessary, such as 15" for exterior wall.
Fittable with brick interior
Standard panel size of 4'x8', though 4'x7" in the present case due to lower ceiling height
Integrate with outer wood walls in that outer walls involve doubling + spacing of inner wall panels

@@ Line 5: / Line 5: @@
 *Fully insulated air tight when joining adjacent panels
 *Allow for slanted sections under roof
-*R19 - ex [http://www.menards.com/main/building-materials/insulation/rolls-batts/6-1-4-t-x-23-w-x-93-l-r-19-kraft-faced-fiberglass-batts/p-1729444-c-5780.htm]
+*Uses R19 fiberglass batts - ex [http://www.menards.com/main/building-materials/insulation/rolls-batts/6-1-4-t-x-23-w-x-93-l-r-19-kraft-faced-fiberglass-batts/p-1729444-c-5780.htm]
 *Uses 2"x6" lumber, integrating with 2"x6" being used for all other structural components.
-*Layers 2 framed sections to achieve any width necessary, such as 15"
+*Layers 2 framed sections to achieve any width necessary, such as 15" for exterior wall.
 *Fittable with brick interior
 *Standard panel size of 4'x8', though 4'x7" in the present case due to lower ceiling height