Revision as of 12:43, 4 September 2014

Requirement

Test-driven Contract-First Requirement - flat surface for meeting with other wall or brick sections
Usable as exterior walls
Usable with any size window of 42"x90" or smaller frame
Usable as a wall unit (exterior or interior), bookshelf, window, or door unit
3/8" plywood face, painted on outside
Detachable with exposed fasteners that can be accessed for deconstruction
Caulked at right angle seams if necessary
Fully insulated air tight when joining adjacent panels
Allow for slanted sections under roof
Uses R19 fiberglass batts - ex [1]
Uses 2"x6" lumber, integrating with 2"x6" being used for all other structural components.
Layers 2 framed sections to achieve any width necessary, such as 15" for exterior wall.
Fittable with brick interior
Standard panel size of 4'x8', though 4'x7" in the present case due to lower ceiling height
Integrate with outer wood walls in that outer walls involve doubling + spacing of inner wall panels
Applicable in nature to inner and outer walls.
Integrated via flat face to window and door panels.
One side is finished and painted upon install. Insulation inside, and second side is open. Closing panel is pre-painted.
Straightness is enforced via plywood edge
Extensible in thickness via spacing and larger plywood
Stackable in height
Extensiblle in lenght via layering

@@ Line 1: / Line 1: @@
 =Requirement=
 *Test-driven Contract-First Requirement - flat surface for meeting with other wall or brick sections
+*Usable as exterior walls
+*Usable with any size window of 42"x90" or smaller frame
+*Usable as a wall unit (exterior or interior), bookshelf, window, or door unit
 *3/8" plywood face, painted on outside
 *Detachable with exposed fasteners that can be accessed for deconstruction