File:Bobcatquickattach.fcstd: Difference between revisions
Jump to navigation
Jump to search
(Marcin uploaded a new version of File:Bobcatquickattach.fcstd) |
(Marcin uploaded a new version of File:Bobcatquickattach.fcstd) |
| (2 intermediate revisions by the same user not shown) | |
(No difference)
| |
Latest revision as of 23:21, 23 September 2017
Initial cut based on geometry of fingers from http://opensourceecology.org/wiki/Bobcat_Standard_Quick_Attach#CAD
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Dimensions | User | Comment | |
|---|---|---|---|---|
| current | 23:21, 23 September 2017 | (31 KB) | Marcin (talk | contribs) | Mid part cut out |
| 23:18, 23 September 2017 | (26 KB) | Marcin (talk | contribs) | Ready to cut out mid section | |
| 23:01, 23 September 2017 | (16 KB) | Marcin (talk | contribs) | Padded the slots so latch points are visible. It would not let me pocket, as sketch was not attached to a face for some reason. | |
| 22:50, 23 September 2017 | (8 KB) | Marcin (talk | contribs) | Made second slot, removed measure lines. | |
| 22:42, 23 September 2017 | (8 KB) | Marcin (talk | contribs) | Added first pin hole for locking implements at 31.5" on center distance. For 42" wide (standard is 44"), this leaves 5.5" to the edge from the center of the hole. Hole is a slot, 1" radius by 4" long. | |
| 06:26, 17 September 2017 | (12 KB) | Marcin (talk | contribs) | Initial cut based on geometry of fingers from http://opensourceecology.org/wiki/Bobcat_Standard_Quick_Attach#CAD |
You cannot overwrite this file.
File usage
There are no pages that use this file.