Shane Log

Welcome! Shane's blog - [1]

Sat Mar 3, 2018

Review of performance:

• Defending Master's thesis - this summer
• Spring for the CNC Circuit mill - put 4 around the rods - weight is about 1 kg, so force constants of 4 springs at 250 g per inch
• Issue resolved - slip of motor - just put a single rubber band on the circuit mill
• Start time sheet -
• Wood backing - appears to be not needed
• Spindle slip from holder - fixed with rubber bands.
• Larger motor driver fixed z motors slipping slightly down
• Software screenshot -

Thu Feb 15 2018

Circuit Mill Development Log: Z Slip Fixed - Promising Results Fixed Z slippage - and some other findings to optimize milling process

Thu Jul 6 2017

OSE D3D Circuit Mill: Steps per mm Calibration

Tue Jun 20 2017

Assembled all axes for CNC router

Mon Mar 13 2017

Began Programming, and Assembly Reference for programming ATTiny

Tues Mar 7 2017

Design Simplification. Simulations complete. Made Parts Table. Ordered Components for first test run.

Fri Feb 24, 2017

Finished Method section of paper. Started milling boards. Ordered parts. Fixed PCB leveling software. Fixed PCB mill issue

Fri Feb 17, 2017

Meeting with Marcin. Sensor Node Designed.

Op-Amp Video

Relevant Links from Discussion:

• Blender Video Sequence Editor (VSE)
• KiCAD Tutorial
• Quite Universal Circuit Simulator (Qucs)
• Open Broadcaster Software

Tue Jan 24, 2017

Researching feasibility of two wire interface (TWI) for communications. Taking a look at current sensor options. Drafting system system hub, and overall system

Tue Jan 22, 2017

Working on Literature review

Tue Jan 17, 2017

Photovoltaics class - discuss project goals with Dr. Pearce. Concept drawing for universal sensor node.

Fri Jan 13, 2017

edit