FreeCAD for 3D Printing: Difference between revisions
Jump to navigation
Jump to search
(Created page with "https://www.youtube.com/watch?v=EaHuY6Dcomo") |
No edit summary |
||
| Line 1: | Line 1: | ||
https://www.youtube.com/watch?v=EaHuY6Dcomo | =Introduction= | ||
3D Printing Design Workbench in FreeCAD could be a bare bones interface that helps novices use FreeCAD. It is preconfigured to get straight into design work - not into setup. The point of a good user interface is that all the setup is done for you - and you can go deeper if you like - but going deeper is not required at startup. | |||
As such, a 3D Printing Design workbench would be a high value - to build on a truly open source solution. | |||
=Other= | |||
*TLDR FreeCAD - https://www.youtube.com/watch?v=EaHuY6Dcomo | |||
Latest revision as of 15:46, 30 April 2018
Introduction
3D Printing Design Workbench in FreeCAD could be a bare bones interface that helps novices use FreeCAD. It is preconfigured to get straight into design work - not into setup. The point of a good user interface is that all the setup is done for you - and you can go deeper if you like - but going deeper is not required at startup.
As such, a 3D Printing Design workbench would be a high value - to build on a truly open source solution.
Other
- TLDR FreeCAD - https://www.youtube.com/watch?v=EaHuY6Dcomo