D3D Development Log: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=Mon May 22, 2018= | =Mon May 22, 2018= | ||
==Basics for Advanced Extruder Operation== | |||
#Validate USA Titan Aero Volcano operation - get all settings correct | |||
#Validate China Titan Aero Volcano - for lower cost sourcing | |||
#Validate card reader + LCD - this is a great improvement on usability and testing upon startup | |||
#Validate double sided adhesion of bed surface - makes sure that the surface never comes off and can stand high temperature printing | |||
#Validate Plexiglas electronics mounting - for tight and transparent cable management and taking up of any slack. Can we laser cut with D3D laser cutter in future iterations. | |||
#Validate frame assembly from welded bar. Must be done in conjunction with self-mixing epoxy method. Could be during next workshop. Needs external frame for welding. Validation shows whether this would be a practical route for remote workshops - otherwise we would need to ship frames. | |||
==Advanced Drivers== | |||
*Validate Trinamic driver quiet operation | *Validate Trinamic driver quiet operation | ||
*Validate sensorless endstop operation with Trinamic drivers | *Validate sensorless endstop operation with Trinamic drivers | ||
| Line 15: | Line 13: | ||
*Validate insulation mounting of bed. | *Validate insulation mounting of bed. | ||
*Validate bottom insulation of bed | *Validate bottom insulation of bed | ||
==Advanced Heat== | |||
*Validate DIY heater beds with steel - 120V for scalable system. | |||
*Validate DIY heater beds for 12V or 24V operation - | |||
*Validate DIY heater beds with aluminum | |||
Revision as of 20:27, 21 May 2018
Mon May 22, 2018
Basics for Advanced Extruder Operation
- Validate USA Titan Aero Volcano operation - get all settings correct
- Validate China Titan Aero Volcano - for lower cost sourcing
- Validate card reader + LCD - this is a great improvement on usability and testing upon startup
- Validate double sided adhesion of bed surface - makes sure that the surface never comes off and can stand high temperature printing
- Validate Plexiglas electronics mounting - for tight and transparent cable management and taking up of any slack. Can we laser cut with D3D laser cutter in future iterations.
- Validate frame assembly from welded bar. Must be done in conjunction with self-mixing epoxy method. Could be during next workshop. Needs external frame for welding. Validation shows whether this would be a practical route for remote workshops - otherwise we would need to ship frames.
Advanced Drivers
- Validate Trinamic driver quiet operation
- Validate sensorless endstop operation with Trinamic drivers
- Validate Volcano cooling fan assembly + sensor mount
- Validate insulation mounting of bed.
- Validate bottom insulation of bed
Advanced Heat
- Validate DIY heater beds with steel - 120V for scalable system.
- Validate DIY heater beds for 12V or 24V operation -
- Validate DIY heater beds with aluminum