D3D v18.06 Data Collection: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
=Homing= | =Homing= | ||
*X and Y home well | *X and Y home well | ||
*Z moves down and stops. Huh? Never seen this before | *Z moves down and stops. Huh? Never seen this before. Z stop triggered without z probe connected? | ||
:*> M119 | |||
< Reporting endstop status | |||
< x_min: open | |||
< y_max: open | |||
< z_min: TRIGGERED | |||
Revision as of 19:40, 6 June 2018
- Note that LCD controller and Cura agree on motion direction. + and - of each axis works equally well in the LCD and in OSE Lulzbot Cura. LCD control is relative from the 0 point.
- Note that if cables are crossed, some steppers work with crossed cables (where order of certain pairs is reversed) - while other steppers do not. This indicates that the internal wiring of the steppers differs between steppers.
Homing
- X and Y home well
- Z moves down and stops. Huh? Never seen this before. Z stop triggered without z probe connected?
- > M119
< Reporting endstop status < x_min: open < y_max: open < z_min: TRIGGERED