Talk:D3D CNC Torch Table: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Design Change Suggestions= ==Flat Bar== I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long a...") |
|||
| Line 10: | Line 10: | ||
[[Image:D3dcnc-changes1.png|400px]] | [[Image:D3dcnc-changes1.png|400px]] | ||
===Printed part=== | |||
could make a part that slips on the two rods, and has groove off to the side that holds steel plate. Wouldnt require cutting holes or different bolts. | |||
Revision as of 15:52, 1 August 2018
Design Change Suggestions
Flat Bar
I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long axis. the sliding part could be tweaked to add a roller bearing to support it self from the flat bar. could bolt a piece of angle iron near the bottom to prevent flexing if needed. --Dorkmo (talk) 04:57, 8 November 2017 (CET)
Printed part
could make a part that slips on the two rods, and has groove off to the side that holds steel plate. Wouldnt require cutting holes or different bolts.