TMC 2130 Stepper Drivers: Difference between revisions
Jump to navigation
Jump to search
Line 11: | Line 11: | ||
*M914 in sensorless homing determines sensitivity of sensorless homing | *M914 in sensorless homing determines sensitivity of sensorless homing | ||
*Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing. | *Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing. | ||
=Analysis of Torque= | |||
*According to test results at 36V - the torque is great in Stealth Mode up to to 250mm/s - [file:///home/ose/Desktop/AN021-stealthChop_Performance_comparison.pdf] | |||
=Wiring Detail= | =Wiring Detail= |
Revision as of 18:09, 15 April 2019
Wire Via SPI for Stealth Mode
- Solder certain bridges on the driver - not easy
- Change Marlin code in configuration_adv.h
- Need to change pins_RAMPS.h file to tell which pins are being used
- Debug allows M122 in serial monitor for status
- Define sensorless_homing in config_adv !!! This is useful.
- Disable endstops_pullup for sensorless homing
- M914 in sensorless homing determines sensitivity of sensorless homing
- Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing.
Analysis of Torque
- According to test results at 36V - the torque is great in Stealth Mode up to to 250mm/s - [file:///home/ose/Desktop/AN021-stealthChop_Performance_comparison.pdf]
Wiring Detail
Source 1
- If smart controller is on Aux 3 - need to wire into Aux 2 headers - see Step 4 at [1]. Disclaimer - author questions validity of LCD working with TMC2130
- Covers 3 parameters set in software - sensitity to bump stop; holding torque; conversion from 16 to 256 microsteps
- Stealth chop gets you less power - how much less? Less speed. Unacceptable for fast bulk prints on large printers
- Can run in hybrid mode to set Stealth mode only below a certain speed, and high speed is noisy.
- Nothing about solder bridge on the driver to select mode?
Links
- Marlin docs on TMC2130 - [2]