TMC 2130 Stepper Drivers: Difference between revisions
Jump to navigation
Jump to search
(→Links) |
(→Links) |
||
Line 26: | Line 26: | ||
*Marlin docs on TMC2130 - [http://marlinfw.org/docs/features/tmc_drivers.html] | *Marlin docs on TMC2130 - [http://marlinfw.org/docs/features/tmc_drivers.html] | ||
*Hackaday post - summary is that it's a job to configure properly - [https://hackaday.com/2016/09/30/3d-printering-trinamic-tmc2130-stepper-motor-drivers-shifting-the-gears/] | *Hackaday post - summary is that it's a job to configure properly - [https://hackaday.com/2016/09/30/3d-printering-trinamic-tmc2130-stepper-motor-drivers-shifting-the-gears/] | ||
*Prusa forum - good list of references - and explanation of low torque is 12v operation instead of 24 or higher. |
Revision as of 18:18, 15 April 2019
Wire Via SPI for Stealth Mode
- Solder certain bridges on the driver - not easy
- Change Marlin code in configuration_adv.h
- Need to change pins_RAMPS.h file to tell which pins are being used
- Debug allows M122 in serial monitor for status
- Define sensorless_homing in config_adv !!! This is useful.
- Disable endstops_pullup for sensorless homing
- M914 in sensorless homing determines sensitivity of sensorless homing
- Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing.
Analysis of Torque
- According to test results at 36V - the torque is great in Stealth Mode up to to 250mm/s - [1]
Wiring Detail
Source 1
- If smart controller is on Aux 3 - need to wire into Aux 2 headers - see Step 4 at [2]. Disclaimer - author questions validity of LCD working with TMC2130
- Covers 3 parameters set in software - sensitity to bump stop; holding torque; conversion from 16 to 256 microsteps
- Stealth chop gets you less power - how much less? Less speed. Unacceptable for fast bulk prints on large printers
- Can run in hybrid mode to set Stealth mode only below a certain speed, and high speed is noisy.
- Nothing about solder bridge on the driver to select mode?