Cat 5 Ampacity: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
Line 46: Line 46:
=Links=
=Links=
*[[Cat 5 Cable]]
*[[Cat 5 Cable]]
*[[Direct Burial Cat 6]]
*[[Cat 6 Direct Burial Shielded Cable]]

Revision as of 21:29, 23 August 2019

Introduction

Ethernet cable is CAT 5 or 6 cable.

http://www.sumidacrossing.org/LayoutElectricity/MRRWire/WireAmpacity/ - says AWG 24 carries 3.5A open and 2A enclosed.


From Stefan H

Under the following assumptions up to 3A should be fine.

  1. 26AWG cat5/6 cable
  2. using two leads
  3. cable is relatively short
  4. normal ambient temps
  5. stepper control (at most use 75% of configured drive current)

Also: https://en.wikipedia.org/wiki/American_wire_gauge

Charts

  • This chart suggests about 1.8A for 8 core wire 23 AWG- [1]. Useful chart in terms of differentiating between the number of cores, but does not consider free air vs enclosed
  • 23 AWG, .7A - [2].Why the 100% difference betweeen different charts?
  • This chart shows free air and derating for bundles, which most approximates open air Cat 5 (8 bundle) - here 23 AWG is 7A*.7 = 5A

Notes

Change on CEB controller: using RJ45 for power-over-cat5. That is a great standard for easy connection, as 8 leads are rated for a total of 16 amps enclosed, and 28 Amps open. So a good product ecology standard for all electrical signal/power transmission in CNC and controls applications. The relevance is the cost and easy connection in prototyping.

We could potentially even consider power over cat 5 for scalable power supplies - such as 8 cat 5 wires get you to a 200A welder - which would be the first use I hear of power electronics over cat 5. I think it's worthwhile because cat 5 is ubiquitously available. Phone burial feeder cable can also be used with Cat 5 ends, no?cc

From Oliver

"Each pair of twisted pairs will need to handle a current of up to 600 mA (Type 3) or 960 mA (Type 4)."

Thats what a pair can handle (in the new upcoming 4PPoE standard), means per wire about 300 mA to 480 mA.

Sourcing

  • Cat6, 23 gauge, 19 cents per foot, 300v rating. [3]
  • 22 ga - [4] exists
  • Sourcing - 1000 feet for $200 - [5]
  • 12 pair 22 awg exists, but is 10x more expensive than 4 pair - [6], so 3x more expensive for the same service.
  • 22 ga 8 conductor unshielded cable - [7]
  • Belden stranded - 24 cents/foot - [8]
  • 100 feet stranded shielded 8 conductor - $38 - [9]
  • 16 cents per foot, unshielded - 22-8C CMP Plenum - [10]

Links