Revision as of 21:44, 4 October 2019

CAD

Angle Connector. - FreeCAD with McMaster 6 mm nut -File:Angleconnector.fcstd. Finished STL - File:Anglecorner.stl

10 cm cut off the bottom, standing on corner - . This would not stand on moving-bed printers.

Revision as of 21:43, 4 October 2019 (view source) Marcin (talk \| contribs) (→‎Production) ← Older edit		Revision as of 21:44, 4 October 2019 (view source) Marcin (talk \| contribs) (→‎Production) Newer edit →
Line 16:		Line 16:

	=Production=		=Production=
	*10 cm cut off the bottom, standing on corner - [[File:angleconnectorstl.png\|500px]]		*10 cm cut off the bottom, standing on corner - [[File:angleconnectorstl.png\|500px]]. This would not stand on moving-bed printers.