Tapping: Difference between revisions
Jump to navigation
Jump to search
(→Types) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Types= | =Types= | ||
There are taper, plug, and bottoming taps: | *There are taper, plug, and bottoming taps: - https://www.spaco.org/taptips.htm | ||
*There are also combo drill-taps - see amazon - [https://www.amazon.com/Migiwata-Combination-Self-centering-Tapping-Aluminum/dp/B07F622N99] | |||
https://www.spaco.org/taptips.htm | |||
=Examples= | =Examples= | ||
| Line 14: | Line 13: | ||
*Same hole and tap using same fixture with drill press - guarantees alignment | *Same hole and tap using same fixture with drill press - guarantees alignment | ||
*The tap self-feeds the drill press downwards. This implies that this would not be doable so well with a hand-held drill. Mag drill would work. | *The tap self-feeds the drill press downwards. This implies that this would not be doable so well with a hand-held drill. Mag drill would work. | ||
*'''Not so!''' - at 10:28 the skilled man shows how to do it with a cordless drill! No tap handle needed. | |||
*''Lot of purists hate it'' | |||
*'''Not a beginner's technique''' | |||
<html><iframe width="560" height="315" src="https://www.youtube.com/embed/I95YrmVUL18" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe></html> | <html><iframe width="560" height="315" src="https://www.youtube.com/embed/I95YrmVUL18" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe></html> | ||
Latest revision as of 23:35, 13 December 2019
Types
- There are taper, plug, and bottoming taps: - https://www.spaco.org/taptips.htm
- There are also combo drill-taps - see amazon - [1]
Examples
- 550 RPM to do a 5 mm hole:
Power Tapping - Tapping with a Drill Press
- Requires 2 flute tap to make it easiest, otherwise chips bind up
- Same hole and tap using same fixture with drill press - guarantees alignment
- The tap self-feeds the drill press downwards. This implies that this would not be doable so well with a hand-held drill. Mag drill would work.
- Not so! - at 10:28 the skilled man shows how to do it with a cordless drill! No tap handle needed.
- Lot of purists hate it
- Not a beginner's technique