Universal Controller Electronics Test Protocol: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
No edit summary
Line 8: Line 8:
#Connect extruder heater
#Connect extruder heater
#Plug in 5 motors and test Prepare-> Auto Home
#Plug in 5 motors and test Prepare-> Auto Home
#To test extruder motor, plug motor into X axis. This doesn't test the extruder driver, so go to Cura
#

Revision as of 20:13, 10 February 2020

  1. Power supply wired, USB power supply, power to Arduino with RAMPS, LCD connected - LCD posts with correct machine name
  2. Plug in 3 endstops
  3. Plug in power supply plug assembly and connect to power supply
  4. Run signal wire to SSR, andFeed 5V from RAMPS to that signal line
  5. Plug in 2 thermistors
  6. Connect power supply to RAMPS, and feed the fan into the same power terminal
  7. Connect blower
  8. Connect extruder heater
  9. Plug in 5 motors and test Prepare-> Auto Home
  10. To test extruder motor, plug motor into X axis. This doesn't test the extruder driver, so go to Cura
Retrieved from "https://wiki.opensourceecology.org/index.php?title=Universal_Controller_Electronics_Test_Protocol&oldid=210957"