STag: Difference between revisions
Jump to navigation
Jump to search
(Fixed an internal link) |
(Fixed an internal link) |
||
| Line 7: | Line 7: | ||
*No unique generator yet, so all are done with the options off of the github...as of now: | *No unique generator yet, so all are done with the options off of the github...as of now: | ||
==SN:00000== | ==SN:00000== | ||
*[[User:Eric]] goofed up the naming scheme lol | |||
*They will test the printable version in [[Meshroom]] tomorrow, 5/18/2020 | |||
===Original=== | ===Original=== | ||
*[[File: STag SN-00000.jpeg]] | *[[File: STag SN-00000.jpeg]] | ||
Revision as of 23:52, 17 May 2020
Basics
- A type of marker for use in 3D Scanning , Motion Capture , and AR/VR/MR
- May be the best/most stable?
- Needs a generator program
Files
- No unique generator yet, so all are done with the options off of the github...as of now:
SN:00000
- User:Eric goofed up the naming scheme lol
- They will test the printable version in Meshroom tomorrow, 5/18/2020
Original
Printable Tracked A3 Paper
- Use 1 Per Dimention
- Then use the corners as set distances
- Assuming paper is accurate + precise (near gaurentee when flat/glued down), and the printer is (again near guarentee at large enough size) is should be an accurate, repeatable, marker
- Also see if a Pen-Holder Toolhead can make it
- File:STag SN-00000 Printable Scanning Distance Standard.jpeg
