STag: Difference between revisions
Jump to navigation
Jump to search
(Minor Text Formating Fix) |
(Minor Clarification) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Basics= | =Basics= | ||
*A type of marker for use in [[3D Scanning]] , [[Motion Capture]] , and AR/VR/MR | *A type of marker for use in [[3D Scanning]] , [[Motion Capture]] , and AR/VR/MR | ||
*Concept/Parameters Outlined by: | |||
**Burak Benligiray | |||
**Cihan Topal | |||
**Cuneyt Akinlar | |||
*May be the best/most stable? | *May be the best/most stable? | ||
* '''Needs a generator program''' | * '''Needs a generator program''' | ||
| Line 11: | Line 15: | ||
===Original=== | ===Original=== | ||
*[[File:STag SN-00000.jpeg | *[[File:STag SN-00000.jpeg.jpeg]] | ||
===Printable Tracked A3 Paper=== | ===Printable Tracked A3 Paper=== | ||
Latest revision as of 00:19, 18 May 2020
Basics
- A type of marker for use in 3D Scanning , Motion Capture , and AR/VR/MR
- Concept/Parameters Outlined by:
- Burak Benligiray
- Cihan Topal
- Cuneyt Akinlar
- May be the best/most stable?
- Needs a generator program
Files
- No unique generator yet, so all are done with the options off of the github...as of now:
SN:00000
- User:Eric goofed up the naming scheme lol
- They will test the printable version in Meshroom tomorrow, 5/18/2020
Original
Printable Tracked A3 Paper
- Use 1 Per Dimention
- Then use the corners as set distances
- Assuming paper is accurate + precise (near gaurentee when flat/glued down), and the printer is (again near guarentee at large enough size) is should be an accurate, repeatable, marker
- Also see if a Pen-Holder Toolhead can make it
