Extruder Test Jig: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 7: | Line 7: | ||
=Results= | =Results= | ||
Minimum acceptable pull force is 5 lb. Tighten extruder spring if this is not the case. Motor skipping indicates limit. If motor skips before 5 lb, verify that motor voltage is sufficient. | |||
*May 22, 2020 - | *May 22, 2020 - | ||
Revision as of 14:39, 22 May 2020
Problem Statement
How do you measure the pull force of the extruder?
Results
Minimum acceptable pull force is 5 lb. Tighten extruder spring if this is not the case. Motor skipping indicates limit. If motor skips before 5 lb, verify that motor voltage is sufficient.
- May 22, 2020 -