Open Source Solar Water Heater: Difference between revisions
Jump to navigation
Jump to search
(Created Page + Added Basic Sections/Info) |
(Updated the page to the more recent formatting style) |
||
Line 56: | Line 56: | ||
*Perhaps Wood or Plastic Exterior | *Perhaps Wood or Plastic Exterior | ||
= | =Internal Links= | ||
* | * | ||
= | =External Links= | ||
* | * |
Revision as of 20:40, 28 July 2020
Basics
- A Device that uses Solar Thermal to heat water
- Can be used from cold to near boiling (see Open Source Solar Steam Generator ) for water to Wet Steam, and Open Source Steam Superheater for Wet Steam to Dry Steam
- There are many ways of doing this but this page will focus on pancake coil type designs, see Open Source Thermosyphon for thermosyphon designs
- This page may use tube/trough designs, but pancake seems like the main one as of now
- Need to look into if these can be grouped for boiling temperatures (this may lead to Steam Hammer and/or overpressure explosions, but perhaps with the right precautions (Steam traps, overpressure valves. etc)
Industry Standards
Existing Open Source Designs
- This Design by the Youtube Channel "Dessertsun02" Uses a copper coil with a metal reflector behind it, and a wood frame
Minimum Viable Product
- Should be able to reach near boiling (~80C is what most existing designs could reach in one stage)
- Should be a small flat square (less than 1m^2 wide, and less than 5 cm deep?)
- Should use standard hose fittings for both the "in" and the "out"
- Optional temperature probes
- perhaps have a thicker and slightly wider model with insulation
Basic Design
Box
- A wood or metal box
- Optional insulation
Backplate
- Sheet metal
- make reflective or dark as well?
Coil
- Standard OTS refrigeration coil, or custom bent tubing
- Has the standard fittings at each end
Insulation
- Foam and/or fiber for the main areas
- Glass and air/vacuum gap above coil, or would the walls and cost make it not worth it?
Temperature Probes
- Attach right above the hose adapters
- Wires go where?
Paint
- Most likely standard black paint, but the darker, the better
- Not 100% needed, but is a cheap way to increase absorbtion
Heat Exchanger?
BOM
- ~1m Sheet Metal (what metal?)
- Fiberglass insulation
- Foam Insulation
- Either copper piping, or an OTS refrigeration coil
- Fittings
- Optional temperature sensors
- Perhaps Wood or Plastic Exterior