Fits, Limits, and Tolerances: Difference between revisions
Jump to navigation
Jump to search
(Created Page + Added Basic Sections/Info) |
(Added some more links under the "External Links" section) |
||
| Line 9: | Line 9: | ||
=External Links= | =External Links= | ||
* | *[https://en.wikipedia.org/wiki/Limits_and_fits The Wikipedia Page on Limits and Fits] | ||
Revision as of 20:21, 21 August 2021
Basics
- This page goes over Fits, Limits, and Tolerances, and the application of them in design
- Essentially nothing is perfect, and getting something closer to perfect is costly/time intensive (see degrees of flatness / Lapping and whatnot) so you define what is acceptable for the application (ie specific hole for a shaft, etc)
- By doing this ahead of time, you take the need for "fiddling" out of the assembly / iterative design process
- Press Fit is a common example