Assemble H-arms: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Cut 54" cross arms *[4] Cut 1/2"x4"x6" angle - 6" long *Mark position of loader shaft *Torch loader shaft, considering *Drill 3 holes on long side and 2 holes on short side **L...") |
(No difference)
|
Revision as of 06:11, 19 June 2011
- Cut 54" cross arms
- [4] Cut 1/2"x4"x6" angle - 6" long
- Mark position of loader shaft
- Torch loader shaft, considering
- Drill 3 holes on long side and 2 holes on short side
- Long side goes on cross arm, shoft side goes on main arms.
- Measure location for mounting of cross arms.