Assemble H-arms: Difference between revisions

Revision as of 06:21, 19 June 2011

Main Arms

Cross Arms

Cut 54" cross arms.
[4] Cut 1/2"x4"x6" angle - 6" long.
Drill 3 holes on long side and 2 holes on short side.
- Long side goes on cross arm, shoft side goes on main arms.
Measure location for mounting of cross arms on the main arms.
Fit and clamp the cross arm in place.
Transfer punch hole locations on one side of loader arms.
Take loader arms off one by one.
Mark other side of cross arm-mounting bolt locations.
Annular cutter mag drill through main arms.
Remount main arms
Fit cross arms and bolt them on, using metal lock nuts.

@@ Line 1: / Line 1: @@
-*Cut 54" cross arms
+'''Main Arms'''
-*[4] Cut 1/2"x4"x6" angle - 6" long
-*Mark position of loader shaft
+*[2] Cut 4-1/2” piece of 1-7/8” DOM.
-*Torch loader shaft, considering
+*[2] Cut 3-1/2” piece of 1-7/8” DOM.
-*Drill 3 holes on long side and 2 holes on short side
+*Mark position of loader shaft for diameter of DOM.
+*Torch loader shaft, considering that 1-7/8” DOM gussets are used.
+*Measure location of loader arms on frame.
+*Torch loader arm location in frame.
+*Place gussets in tractor frame.
+*Fit 1-7/8” shaft through gussets.
+*[2] Mount 1-7/8” washers outside of frame and inside of arms.
+*Insert DOM gusset into loader arm.
+*Mount 1 loader arm at a time onto the shaft.
+'''Cross Arms'''
+*Cut 54" cross arms.
+*[4] Cut 1/2"x4"x6" angle - 6" long.
+*Drill 3 holes on long side and 2 holes on short side.
 **Long side goes on cross arm, shoft side goes on main arms.
-*Measure location for mounting of cross arms.
+*Measure location for mounting of cross arms on the main arms.
+*Fit and clamp the cross arm in place.
+*Transfer punch hole locations on one side of loader arms.
+*Take loader arms off one by one.
+*Mark other side of cross arm-mounting bolt locations.
+*Annular cutter mag drill through main arms.
+*Remount main arms
+*Fit cross arms and bolt them on, using metal lock nuts.
+[[Category:Fabrication Procedures]]