LT3 documentation TODOs: Difference between revisions
(Created page with " Loader Arm Round, I'm pretty sure the tube wall should not be 1/2" thick steel. Seems that some dimensions are mixing diameter and radius for the Wheel Mount Round. The thic...") |
No edit summary |
||
| Line 1: | Line 1: | ||
1. Do a full exploded part diagram for the tractor, labeling each part with a number | |||
2. Show a 2D technical drawing for each part, labeled by the number you used in the exploded part diagram. | |||
Do a separate page for each part. On each page, we can then retrofit labels and other fabrication procedure information - though I don't know how Solidworks handles such labels. | |||
Revision as of 18:29, 14 September 2011
1. Do a full exploded part diagram for the tractor, labeling each part with a number 2. Show a 2D technical drawing for each part, labeled by the number you used in the exploded part diagram. Do a separate page for each part. On each page, we can then retrofit labels and other fabrication procedure information - though I don't know how Solidworks handles such labels.
Loader Arm Round, I'm pretty sure the tube wall should not be 1/2" thick steel.
Seems that some dimensions are mixing diameter and radius for the Wheel Mount Round.
The thickness is specified at 5/16", but the difference between the ID and OD is 5/8".
I revived the "Old" sheet of the BOM spreadsheet and am updating it with the new PDF drawings, but can't match the item names to those in the PDF drawing. In the spreadsheet, I put the old names in (parens) and put the new name in front. Can you check it and match up the outstanding names?
The spreadsheet is on the "Steel" sheet at the bottom of the spreadsheet:
http://opensourceecology.org/wiki/LifeTrac/Bill_of_Materials#Bill_Of_Materials