User:Dorkmo/Log: Difference between revisions
Jump to navigation
Jump to search
| Line 2: | Line 2: | ||
prep for making some detroit boards + full documentation | prep for making some detroit boards + full documentation | ||
*made two sets and sent back to fef | |||
*started documenting process | |||
*waiting on tulsa fab lab to open for business to cut two more boards for texas folks | |||
slowing working on a personal prusa | slowing working on a personal prusa | ||
*S. Korean stepper motors on back order | |||
prep for making a [[Snap-Lock]] | prep for making a [[Snap-Lock]] | ||
*got a 24x48x1/2 hdpe sheet | |||
*ordered a bit for shopbot to use when tulsa fab lab opens | |||
prep for experimenting with solenoids | prep for experimenting with solenoids | ||
*spooled up a few for practice | |||
*need to figure out power sourcing | |||
light wiki editing | light wiki editing | ||
*did a little towards measurizing ceb model | |||
== 08/2012 == | == 08/2012 == | ||
Revision as of 00:43, 30 September 2011
09/2012
prep for making some detroit boards + full documentation
- made two sets and sent back to fef
- started documenting process
- waiting on tulsa fab lab to open for business to cut two more boards for texas folks
slowing working on a personal prusa
- S. Korean stepper motors on back order
prep for making a Snap-Lock
- got a 24x48x1/2 hdpe sheet
- ordered a bit for shopbot to use when tulsa fab lab opens
prep for experimenting with solenoids
- spooled up a few for practice
- need to figure out power sourcing
light wiki editing
- did a little towards measurizing ceb model
08/2012
wired 4 ceb press control boxes (exluding arduinos)
assisted adam with clearing & roof
made some ceb sensor assemblies with cody