Power Cube Complete machine fabrication: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Created page with "==Assembly== <ref>[http://hydraulics.eaton.com/products/pdfs/694.pdf Hydraulic Hints and Troubleshooting Guide, Eaton]</ref> * Most important – cleanliness. * All openings in t...")
 
No edit summary
 
(5 intermediate revisions by 2 users not shown)
Line 1: Line 1:
==Assembly==
<html>
<ref>[http://hydraulics.eaton.com/products/pdfs/694.pdf Hydraulic Hints and Troubleshooting Guide, Eaton]</ref>
<iframe src="https://player.vimeo.com/video/29562529?title=0&amp;byline=0&amp;portrait=0" width="400" height="225" frameborder="0" webkitAllowFullScreen mozallowfullscreen allowFullScreen></iframe>
* Most important – cleanliness.
</html>
* All openings in the reservoir should be sealed after cleaning.
* No grinding or welding operations should be done in the area where hydraulic components are being installed.
* All cylinder, valve, pump and hose connections should be sealed and/or capped until just prior to use.
* Mineral spirits should be kept in safety containers.
* Air hoses can be used to clean fittings and other system components. However, the air supply must be filtered and dry to prevent contamination of the parts.
* Examine pipe fittings and hose assemblies prior to use to be certain that burrs, dirt and/or scale are not present.
* All pipe and tubing ends should be reamed to prevent restriction and turbulent flow.
* Do not use Teflon tape on straight thread connections.
* When installing pumps or motors, always align coupling halves as closely as possible, within 0.007 inch.
* When using flexible couplings, follow the manufacturer’s recommendations or allow 1/32 to 1/16 inch clearance between the coupling halves.
* Do not drive couplings on pump or motor shafts. They should be a slip fit, or shrunk on using hot oil.
* Always use a dry spray-on lubricant on splines when installing. This prevents wear and adds to the life of the splines.
* When using double universal joint couplings, the shafts must be parallel and the yokes must be in line.
* When installing V-belt pulleys on pumps or motors, line up both pulleys as closely as possible. Always install the pulleys with a minimum amount of overhang as close to the pump or motor face as possible. This increases bearing service life.


==References==
<html>
<references />
<iframe src="https://player.vimeo.com/video/29466230?title=0&amp;byline=0&amp;portrait=0" width="400" height="225" frameborder="0" webkitAllowFullScreen mozallowfullscreen allowFullScreen></iframe>
</html>

Latest revision as of 12:22, 25 December 2011

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Power_Cube_Complete_machine_fabrication&oldid=49474"