Cold Saw/V1 Design Files/Clamp Block: Difference between revisions
< Cold Saw | V1 Design Files
Jump to navigation
Jump to search
No edit summary |
|||
| Line 13: | Line 13: | ||
*'''Jaw Hole Spacing Along Length: 30mm''' | *'''Jaw Hole Spacing Along Length: 30mm''' | ||
*Jaw Hole Notes: The fastener hole is closer to the center of the vise so that a jaw of the same slot length can move closer to the center of the clamping volume. | |||
Revision as of 22:53, 7 June 2012
Clamp Block
- Length: 50mm
- Width: 25.4mm
- Height: 25.4mm
- Jaw Hole Diameter: 10.5mm DIA then M12x1.75 Tap
- Jaw Hole Height: 13mm
- Jaw Hole Spacing Along Length: 30mm
- Jaw Hole Notes: The fastener hole is closer to the center of the vise so that a jaw of the same slot length can move closer to the center of the clamping volume.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF