|
|
| (One intermediate revision by the same user not shown) |
| Line 1: |
Line 1: |
| =Moving Block= | | =3D Model= |
| | |
| *'''Length: 250mm'''
| |
| | |
| *'''Width: 50.8mm'''
| |
| | |
| *'''Height: 76.2mm'''
| |
| | |
| | |
| *'''Clamp Axis Centerline Height: 22mm'''
| |
| | |
| | |
| *'''Clamp Jaw Hole Spacing Along Height: 63.5mm'''
| |
| | |
| *'''Clamp Jaw Hole Diameter: 10.5mm DIA then M12x1.75 Tap'''
| |
| | |
| *'''Clamp Jaw Hole Spacing Along Length: 30mm, 220mm'''
| |
| | |
| | |
| *'''Cutout Length: 250mm'''
| |
| | |
| *'''Cutout Width: 25.4mm'''
| |
| | |
| *'''Cutout Height: 25.4mm'''
| |
| | |
| *'''Cutout Spacing Along Width: On Side'''
| |
| | |
| | |
| *'''Cutout Length: 150mm'''
| |
| | |
| *'''Cutout Width: 25.4mm'''
| |
| | |
| *'''Cutout Height: 25.4mm'''
| |
| | |
| *'''Cutout Spacing Along Length: Centered'''
| |
| | |
| | |
| *'''Width Notes: The width must be great enough so as to minimize the friction generated between the Moving Block and the Shafts under tension. If the width is too low, then the operator will not be able to clamp the workpiece with greater tension after a certain friction-caused stall point.'''
| |
| | |
| *'''Cutout Notes: The cutout is necessary to accommodate angled cuts on the vise while retaining width of the Moving Block.'''
| |
| | |
| | |
| *'''2D Image'''
| |
|
| |
|
| [[Image: ColdSawV1MovingBlock.jpg|500px]] | | [[Image: ColdSawV1MovingBlock.jpg|500px]] |
|
| |
| *'''3D CAD STP'''
| |
|
| |
|
| [[File: ColdSawV1MovingBlock.stp]] | | [[File: ColdSawV1MovingBlock.stp]] |
|
| |
|
| *'''2D Fabrication Drawing PDF'''
| | =2D Drawing= |
|
| |
|
| [[File: ColdSawV1MovingBlock.pdf]] | | [[File: ColdSawV1MovingBlock.pdf]] |
|
| |
| *'''2D Fabrication Drawing DXF'''
| |
|
| |
| [[File: ColdSawV1MovingBlock.dxf]]
| |
