Lathe Specifications: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
==Fabrication and Cost== | |||
*Ease and low cost of fabrication is the primary goal, as a high-performance lathe is perhaps the most important tool in a workshop | *Ease and low cost of fabrication is the primary goal, as a high-performance lathe is perhaps the most important tool in a workshop | ||
*Construction consists of a concrete bed | *Construction consists of a concrete bed | ||
| Line 10: | Line 10: | ||
*2" shaft constitutes a mounting surface for an xy table and for tail stock | *2" shaft constitutes a mounting surface for an xy table and for tail stock | ||
*Feed-through shaft is present, but is only 1 foot deep | *Feed-through shaft is present, but is only 1 foot deep | ||
*[http://surpluscenter.com/item.asp?UID=2009030121420114&item=1-215-47-4-S&catname=powerTrans Cheap 2 15/16" bearing] | |||
[[Image:Lathe.jpg]] | [[Image:Lathe.jpg]] | ||
==Specifications== | |||
*12" lathe | *12" lathe | ||
*1/1000" accuracy via bearing tolerance and chuck tolerance | *1/1000" accuracy via bearing tolerance and chuck tolerance | ||
*Heavy duty axial thrust acceptable, as determined by 3" shaft and bearings | *Heavy duty axial thrust acceptable, as determined by 3" shaft and bearings | ||
*Radial thrust determined by set screws on 2 bearings, with 2 extra full split collars | *Radial thrust determined by set screws on 2 bearings, with 2 extra full split collars | ||
=BOM= | |||
*http://www.thebigbearingstore.com/servlet/the-57/2%22-Pillow-Block-Bearing/Detail | |||
* | |||
[[Category:Specifications]] | [[Category:Specifications]] | ||
Latest revision as of 09:13, 17 March 2009
Fabrication and Cost
- Ease and low cost of fabrication is the primary goal, as a high-performance lathe is perhaps the most important tool in a workshop
- Construction consists of a concrete bed
- Cost is that of 4 bags of concrete for the bed, chuck, cross slide, and
- Motor cost is included in LifeTrac infrastructure
- Motor coupler to lathe shaft is machined
- Commercial chck is the main cost
- XY table constitutes a cross slide
- Tool post is fabricated
- 2" shaft constitutes a mounting surface for an xy table and for tail stock
- Feed-through shaft is present, but is only 1 foot deep
- Cheap 2 15/16" bearing
Specifications
- 12" lathe
- 1/1000" accuracy via bearing tolerance and chuck tolerance
- Heavy duty axial thrust acceptable, as determined by 3" shaft and bearings
- Radial thrust determined by set screws on 2 bearings, with 2 extra full split collars