Thermal Dynamics Cutmaster 52: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
*Operating Manual - [http://victortechnologies.com/IM_Uploads/DocLib_7373_Victor%20Thermal%20Dynamics%20Cutmaster%2052%20Operating%20Manual_(0-4961)_Nov2012.pdf] | *Operating Manual - [http://victortechnologies.com/IM_Uploads/DocLib_7373_Victor%20Thermal%20Dynamics%20Cutmaster%2052%20Operating%20Manual_(0-4961)_Nov2012.pdf] | ||
*Service Manual - [http://victortechnologies.com/IM_Uploads/DocLib_2235_Victor%20Thermal%20Dynamics%20Cutmaster%2052%20Service%20Manual_(0-4962)_Nov2012.pdf] | *Service Manual - [http://victortechnologies.com/IM_Uploads/DocLib_2235_Victor%20Thermal%20Dynamics%20Cutmaster%2052%20Service%20Manual_(0-4962)_Nov2012.pdf] | ||
=Troubleshooting= | |||
Short Torch Parts Life: | |||
#Oil or moisture in air source. | |||
#Exceeding system capability | |||
(material too thick). | |||
#Excessive pilot arc time | |||
#Gas pressure too low. | |||
#Improperly assembled torch. | |||
#Non - Genuine Thermal Dynamics | |||
parts used | |||
Revision as of 21:52, 25 June 2013
http://www.weldingsuppliesfromioc.com/thermal-dynamics-cutmaster-52-plasma-cutter-1-5130-1
Troubleshooting
Short Torch Parts Life:
- Oil or moisture in air source.
- Exceeding system capability
(material too thick).
- Excessive pilot arc time
- Gas pressure too low.
- Improperly assembled torch.
- Non - Genuine Thermal Dynamics
parts used