How to Make Arduino Cables: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
*https://arduino-info.wikispaces.com/Cables#flatcable | *https://arduino-info.wikispaces.com/Cables#flatcable | ||
=These are Dupont Connectors= | |||
=From Source= | =From Source= | ||
| Line 8: | Line 10: | ||
*Crimping tool can put both male and female pins into the housing: | *Crimping tool can put both male and female pins into the housing: | ||
<html><iframe width="560" height="315" src="https://www.youtube.com/embed/GkbOJSvhCgU" frameborder="0" allowfullscreen></iframe></html> | <html><iframe width="560" height="315" src="https://www.youtube.com/embed/GkbOJSvhCgU" frameborder="0" allowfullscreen></iframe></html> | ||
=Stepper Motor Connectors= | |||
*How to figure out windings - | |||
<html><iframe width="560" height="315" src="https://www.youtube.com/embed/IEmGOuMFPKQ" frameborder="0" allowfullscreen></iframe></html> | |||
*JST PHR-6 connectors - typical for Nema 17 motors - [https://www.digikey.com/product-detail/en/jst-sales-america-inc/PHR-6/455-1162-ND/608604] | |||
*About JST connectors - these are connectors for Nema 17 Steppers, for example. | |||
<html><iframe width="560" height="315" src="https://www.youtube.com/embed/wn3ixZ-sv5w" frameborder="0" allowfullscreen></iframe></html> | |||
*Regarding JST - we'd like to know how to make the actual wire + connector | |||
Latest revision as of 18:34, 12 May 2017
Ready Made
These are Dupont Connectors
From Source
- Insulation Displacement Connectors (IDC or IPC) [1] use piercing of insulation for the terminal. Here is an example of the cable - [2]
- Dupont connectors - with M/F housings + pin headers - [3]
- Crimping tool can put both male and female pins into the housing:
Stepper Motor Connectors
- How to figure out windings -
- JST PHR-6 connectors - typical for Nema 17 motors - [4]
- About JST connectors - these are connectors for Nema 17 Steppers, for example.
- Regarding JST - we'd like to know how to make the actual wire + connector