Multimachine Parts: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(New page: #[http://www.use-enco.com/CGI/INSRIT?PMAKA=201-2826&PMPXNO=951820&PARTPG=INLMK3 Cross Slide])
 
No edit summary
 
(3 intermediate revisions by 2 users not shown)
Line 1: Line 1:
#[http://www.use-enco.com/CGI/INSRIT?PMAKA=201-2826&PMPXNO=951820&PARTPG=INLMK3 Cross Slide]
=Introduction=
 
This is a detailed parts list for a 2-engine block [[Multimachine]] powered by a hydraulic motor running from [[LifeTrac]] hydraulics.
 
'''Engine Blocks'''
 
#Block 1 -
#Block 2 -
#Mounting between both engine blocks -
 
'''Spindle'''
 
#Shaft - 3.5" XXHW pipe, 2.875 OD, 1.771 ID
#Bearings - 65 mm (about 2.6") ID [http://bearingsdirect.com/products/index.php?action=item&id=5062&prevaction=category&previd=9&prevstart=25 tapered bearings]
#Clamps -
 
'''Chuck'''
 
#Chuck mounting plate -
#Chuck -
#Chuck key -
 
'''Tool Holders'''
 
#Cross slide - [http://www.use-enco.com/CGI/INSRIT?PMAKA=201-2826&PMPXNO=951820&PARTPG=INLMK3]
#Tool post for lathing -
#Lathe bits -
 
'''Engine Stand'''
 
#
 
'''Motor'''
 
[[Category: Multimachine]]

Latest revision as of 10:24, 3 May 2011

Introduction

This is a detailed parts list for a 2-engine block Multimachine powered by a hydraulic motor running from LifeTrac hydraulics.

Engine Blocks

  1. Block 1 -
  2. Block 2 -
  3. Mounting between both engine blocks -

Spindle

  1. Shaft - 3.5" XXHW pipe, 2.875 OD, 1.771 ID
  2. Bearings - 65 mm (about 2.6") ID tapered bearings
  3. Clamps -

Chuck

  1. Chuck mounting plate -
  2. Chuck -
  3. Chuck key -

Tool Holders

  1. Cross slide - [1]
  2. Tool post for lathing -
  3. Lathe bits -

Engine Stand

Motor

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Multimachine_Parts&oldid=24509"