Multimachine Parts: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
=Introduction= | =Introduction= | ||
This is a detailed parts list for a 2-engine block Multimachine powered by a hydraulic motor running from [[LifeTrac]] hydraulics. | This is a detailed parts list for a 2-engine block [[Multimachine]] powered by a hydraulic motor running from [[LifeTrac]] hydraulics. | ||
'''Engine Blocks''' | '''Engine Blocks''' | ||
| Line 11: | Line 11: | ||
'''Spindle''' | '''Spindle''' | ||
#Shaft - | #Shaft - 3.5" XXHW pipe, 2.875 OD, 1.771 ID | ||
#Bearings - | #Bearings - 65 mm (about 2.6") ID [http://bearingsdirect.com/products/index.php?action=item&id=5062&prevaction=category&previd=9&prevstart=25 tapered bearings] | ||
#Clamps - | #Clamps - | ||
| Line 32: | Line 32: | ||
'''Motor''' | '''Motor''' | ||
[[Category: Multimachine]] | |||
Latest revision as of 10:24, 3 May 2011
Introduction
This is a detailed parts list for a 2-engine block Multimachine powered by a hydraulic motor running from LifeTrac hydraulics.
Engine Blocks
- Block 1 -
- Block 2 -
- Mounting between both engine blocks -
Spindle
- Shaft - 3.5" XXHW pipe, 2.875 OD, 1.771 ID
- Bearings - 65 mm (about 2.6") ID tapered bearings
- Clamps -
Chuck
- Chuck mounting plate -
- Chuck -
- Chuck key -
Tool Holders
- Cross slide - [1]
- Tool post for lathing -
- Lathe bits -
Engine Stand
Motor