OSE Filament Extruder v21.10 Data Collection: Difference between revisions
Jump to navigation
Jump to search
(Asked for some clarification on some questions I had) |
m (Asked for some clarification on some questions I had) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
*Was a [[Filament Diameter Sensor]] (Or just periodic sampling with a [[Micrometer]] ) done? | *Was a [[Filament Diameter Sensor]] (Or just periodic sampling with a [[Micrometer]] ) done? | ||
*If so what were the typical tolerances? | *If so what were the typical tolerances? | ||
*[https://www.facebook.com/marcin.jakubowski.378/posts/10214259195730970?ref=embed_post As of this post] , seems "Sample filament varies from .205 to .225 in the sample shown before any quality control." is to be expected? | |||
[[Category: OSE Filament Extruder]] | |||
Latest revision as of 23:17, 26 September 2023
Temperature Records
Filament Tolerances
- Was a Filament Diameter Sensor (Or just periodic sampling with a Micrometer ) done?
- If so what were the typical tolerances?
- As of this post , seems "Sample filament varies from .205 to .225 in the sample shown before any quality control." is to be expected?