LifeTrac/Trailer Ball Quick Attach: Difference between revisions
< LifeTrac
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
This is a plate for the | This is a plate for the LifeTrac so you can tow trailers with it. | ||
<gallery widths="300" heights="200"> | |||
Image:balloff.jpg|The QA profile | |||
Image:Ballattached.jpg|The QA installed | |||
</gallery> | |||
==Materials:== | ==Materials:== | ||
Latest revision as of 01:59, 22 August 2011
This is a plate for the LifeTrac so you can tow trailers with it.
The QA profile
The QA installed
Materials:
- 1/2"x4" plate- 4", 6" (2) [10" total]
- 1/2"x6" plate-10" (1)
- Trailer Ball
- 3/4"x5" Bolt
Fabrication instructions
- Torch a hole to fit the trailer ball in the 1/2"x4"x4" piece, as close as possible to where it is to be welded. Insure the ball can still be turned and tightened.
- Weld this plate centered, and square, about an inch from the top of the 1/2"x6" piece.
- Flip the assembly over and weld the 4"x6" strip to the back, at the proper quick attach angle (a deflection of 2 1/4" over it's length)
- Mount this to the tractor and mark where the hole at the bottom end needs to be torched
- Torch the hole and clean it up.
- Install the ball.