CNC Circuit Mill/Manufacturing Instructions: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Redirected page to CNC Machine)
 
(64 intermediate revisions by 3 users not shown)
Line 1: Line 1:
=1 Preparation=
#redirect [[CNC Machine]]
 
*
<html><iframe width='800' height='300' frameborder='0' src='
 
https://docs.google.com/spreadsheet/pub?hl=en_US&hl=en_US&key=0AlpsBarfpPkzdFk5aDY3dHM0eEhfZHNkWVppdV9EelE&output=html
 
'></iframe>
</html><br/>
 
*Edit
 
https://docs.google.com/spreadsheet/ccc?key=0AlpsBarfpPkzdFk5aDY3dHM0eEhfZHNkWVppdV9EelE
 
=1 Process=
 
*Angle Template
 
70mm long, 0.125" x 1" x 1" steel angle.
 
Use pilot bit. Differentiate the 2 holes as A and B after drilling. Which is which does not matter.
 
Mark and drill hole A on one angle side, 13mm from the inner joining edge of angle, close to the end of the angle.
 
Mark and drill hole B on the other angle side, 13 from the inner joining edge of angle, 26mm apart (distance is angle-parallel) from hole A.
 
*Tube Template
 
0.125" x 1" x 1" x 180mm steel tube.
 
All holes drilled with only pilot bit. Keep angle template usage consistent by keeping its 2 tube contact faces the same for all holes for a given surface. Ensure tube is on flat surface.
 
Use angle template hole A to drill reference hole near end of tube.
 
Mark 15.5mm tube-parallel from reference hole then drill 2 holes each 15.5mm tube-perpendicular from mark.
 
Mark 25mm tube-parallel from reference hole then drill 1 hole at mark using angle template hole A.
 
Mark 50mm tube-parallel from reference hole then drill 1 hole at mark using angle template hole A.
 
Mark 170mm tube-parallel from reference hole then drill 1 hole at mark using angle template hole A.
 
Drill 1 hole using angle template hole B while hole A is set to the 50mm hole with rod.
 
Drill 1 hole using angle template hole B while hole A is set to the 170mm hole with rod.
 
*Edit Processing Folder (copy/paste "Arduino1.0/lib/RXTcomm.jar" into Processing/lib)
 
*Edit GRBL Folder (edit "MakeFile" such that the serial port name "...tty.usb*" is replaced with the correct name corresponding to your computer OS)
 
*Upload Microcontroller Code
 
http://opensourceecology.org/wiki/CNC_Circuit_Mill/Manufacturing_Instructions/Upload_Microcontroller_Code
 
*Run '''gctrl code''' as a '''processing''' sketch. For any function of gctrl, press and hold down the key for the popup windows to populate.

Latest revision as of 04:17, 26 June 2014

Redirect to:

Retrieved from "https://wiki.opensourceecology.org/index.php?title=CNC_Circuit_Mill/Manufacturing_Instructions&oldid=120890"