CNC Circuit Mill: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Fixed an internal link)
 
(128 intermediate revisions by 8 users not shown)
Line 1: Line 1:
=Introduction=
#REDIRECT [[D3D CNC Circuit Mill]]
 
*'''Example of CNC Circuit Milling on a Commercial CNC Circuit Mill'''
 
<html>
 
<iframe width="320" height="247" src="https://www.youtube.com/embed//oEQsAi_eRAI" frameborder="0" allowfullscreen></iframe>
 
</html>
 
 
*As you can see, the milling bit rotates at very high speeds (thousands of complete rotations per minute, aka "revolutions per minute" or just "rpm") and removes material from the top layer (and a bit of the bottom layer) of the circuit board.
 
*The circuit board is comprised of a thin top layer of conductive material (often copper) that is adhered to a layer of insulating material below.
 
*During milling, the insulating layer provides a safety gap between the milling bit and the precision work surface (which should not be marred).
 
*Once the milling is complete, the remaining copper traces form the actual conductive circuit (without the components soldered yet), while the relatively intact insulating layer gives the circuit board its rigidity.
 
=Industry Standards=
 
*'''LPKF'''
 
http://www.lpkfusa.com/downloads/support/docs/man_c40.pdf
 
*'''Tormach: PCNC 1100 Series 3 CNC Mill'''
 
http://www.tormach.com/Product_PCNC_main2.html?gclid=CNqspeb8r64CFUcCQAodmBSZRw
 
http://www.tormach.com/uploads/300/TD_Series_3_Whitepaper_v4-0-pdf.html
 
Ballscrews and nuts, hybrid polyphase stepper motors, microstepping digital electronics
 
=Iterations=
 
*'''Version In Progress'''
[[CNCCMV2]]
 
*'''Version 1'''
 
[[CNCCMV1]]
 
==See Also==
*[[CNC Circuit Mill Discussion]]
*[[CNC Circuit Mill Concept]]
*[[Stepper Motor]]
*[http://blog.ponoko.com/2011/07/15/pricing-guide-to-diy-cnc-mill-and-router-kits/ Comparison of CNC kits]
*[[Mantis 9]]
*[[Snaplock]]
*[[Shapeoko]]
 
*[http://en.wikipedia.org/wiki/Printed_circuit_board_milling Wikipedia: Printed Circuit Board Milling]
 
[[Category:Circuit Board Fabrication]]
 
{{GVCS Footer}}

Latest revision as of 01:39, 14 March 2019

Redirect to:

Retrieved from "https://wiki.opensourceecology.org/index.php?title=CNC_Circuit_Mill&oldid=187764"