Cold Saw/V1 Design Files/Support Bar: Difference between revisions
< Cold Saw | V1 Design Files
Jump to navigation
Jump to search
(Created page with "=Support Bar= *'''2D Image''' 500px *'''3D CAD STP''' File: ColdSawV1SupportBar.stp *'''2D Fabrication Drawing PDF''' [[File: ColdSaw...") |
|||
| (12 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Support Bar= | =Support Bar= | ||
*'''Length: 300mm''' | |||
*'''Width: 127mm''' | |||
*'''Thickness: 25.4mm''' | |||
*'''Shaft Hole Diameter: 32mm''' | |||
*'''Shaft Hole Spacing Along Length: 260mm''' | |||
*'''Shaft Hole Spacing Along Width: 23.5mm''' | |||
*'''Shaft Hole Spacing: minimum of 40mm from part ends''' | |||
*'''Interface Hole Diameter: 12mm''' | |||
*'''Interface Hole Rectangle: 75mm x 80mm''' | |||
*'''Stopper Hole Diameter: 12mm''' | |||
*'''Stopper Hole Spacing: 30mm x 45mm from Shaft Hole. (Such that the blade bottoms out just before touching the vise; such that the drive assembly can reliably and safely sit back without being held)''' | |||
*'''Stopper Notes: Remember that the stopper screw will have a nut on it which determines the contact diameter of the stopper.''' | |||
*'''2D Image''' | *'''2D Image''' | ||
Latest revision as of 23:31, 7 June 2012
Support Bar
- Length: 300mm
- Width: 127mm
- Thickness: 25.4mm
- Shaft Hole Diameter: 32mm
- Shaft Hole Spacing Along Length: 260mm
- Shaft Hole Spacing Along Width: 23.5mm
- Shaft Hole Spacing: minimum of 40mm from part ends
- Interface Hole Diameter: 12mm
- Interface Hole Rectangle: 75mm x 80mm
- Stopper Hole Diameter: 12mm
- Stopper Hole Spacing: 30mm x 45mm from Shaft Hole. (Such that the blade bottoms out just before touching the vise; such that the drive assembly can reliably and safely sit back without being held)
- Stopper Notes: Remember that the stopper screw will have a nut on it which determines the contact diameter of the stopper.
- 2D Image
- 3D CAD STP
- 2D Fabrication Drawing PDF
- 2D Fabrication Drawing DXF