Latest revision as of 22:54, 15 June 2012

Swivel Plate

Length: 406.4mm (Long enough to support the drive assembly such that the blade is centered on the vise)

Width: 203.2mm (Wide enough to fit the shaft blocks wide enough to support the drive assembly such that the blade is centered on the vise)

@@ Line 1: / Line 1: @@
 =Swivel Plate=
-*'''Length: 457.2mm'''
+*'''Length: 406.4mm''' (Long enough to support the drive assembly such that the blade is centered on the vise)
-*'''Width: 304.8mm'''
+*'''Width: 203.2mm''' (Wide enough to fit the shaft blocks wide enough to support the drive assembly such that the blade is centered on the vise)
 *'''Thickness: 25.4mm'''
-*'''Swivel Hole Diameter: 150mm'''
-*'''Swivel Hole Spacing Along Length: 335mm'''
+*'''Swivel Hole Diameter: 30mm'''
-*'''Swivel Hole Spacing Along Width: 190mm'''
+*'''Swivel Hole Along Length; Near Edge'''
-*'''Support Hole Diameter: 12mm with 25mm dia 8 deep countersink'''
-*'''Support Hole Spacing Along Length: 30mm, 85mm'''
-*'''Support Hole Spacing Along Width: 25.4mm, 190mm'''
-*'''Clamp Hole Diameter: 10.5mm dia, then M12x1.75 tapped'''
-*'''Clamp Hole Spacing Along Width: 190mm''' (Swivel Hole Spacing Along Width)
-*'''Clamp Hole Spacing Along Height: 12.7mm''' (Swivel Plate Thickness / 2)
+*'''Swivel Hole Spacing Along Width: Centered'''