|
|
| (5 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| =Clamp Block= | | =Left Clamp Block= |
|
| |
|
| *'''Length: 50mm'''
| | ==3D Model== |
| | |
| *'''Width: 25.4mm'''
| |
| | |
| *'''Height: 25.4mm'''
| |
| | |
| | |
| *'''Jaw Hole Diameter: 10.5mm DIA then M12x1.75 Tap'''
| |
| | |
| *'''Jaw Hole Height: 13mm'''
| |
| | |
| *'''Jaw Hole Spacing Along Length: 30mm'''
| |
| | |
| | |
| *Jaw Hole Notes: The fastener hole is closer to the center of the vise so that a jaw of the same slot length can move closer to the center of the clamping volume. Also, the fastener hole being closer to the center of clamping volume increases rigidity of the clamping center because the fastening compression occurs closer to the center.
| |
| | |
| | |
| *'''2D Image'''
| |
|
| |
|
| [[Image: ColdSawV1ClampBlock.jpg|500px]] | | [[Image: ColdSawV1ClampBlock.jpg|500px]] |
|
| |
|
| *'''3D CAD STP'''
| | [[File: ColdSawV1ClampBlock.stp]] |
|
| |
|
| [[File: ColdSawV1ClampBlock.stp]]
| | ==2D Drawing== |
|
| |
|
| *'''2D Fabrication Drawing PDF'''
| | [[File: ColdSawV1ClampBlock2.jpg]] |
|
| |
|
| [[File: ColdSawV1ClampBlock.pdf]] | | [[File: ColdSawV1ClampBlock.pdf]] |
|
| |
| *'''2D Fabrication Drawing DXF'''
| |
|
| |
| [[File: ColdSawV1ClampBlock.dxf]]
| |
Latest revision as of 06:41, 1 July 2012
