Everlast PowerPro 256: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (6 intermediate revisions by the same user not shown) | |||
| Line 8: | Line 8: | ||
*[http://www.everlastgenerators.com/downloads/PowerPro-and-PowerUltra.pdf Manual] | *[http://www.everlastgenerators.com/downloads/PowerPro-and-PowerUltra.pdf Manual] | ||
==Tutorial Videos== | ===Plasma Cutter Settings=== | ||
*cut mode | |||
*poles set at dc | |||
*turn all green knobs to left except for the post flow | |||
*pulse off | |||
*2t mode | |||
*main amperage control - 50 or 60 | |||
*if we have the amperage control to 60 = we'll be drawing 50 amps | |||
*ground clamp as close to the metal as possible | |||
*maintain about 70 to 75 psi on the air compressor | |||
*4 cf/ minute on the air compressor | |||
==Plasma Cutting Tutorial== | |||
<html> | |||
<iframe width="560" height="315" src="https://www.youtube.com/embed//cyKMPf0vs2M" frameborder="0" allowfullscreen></iframe> | |||
</html> | |||
==TIG Tutorial Videos== | |||
<html> | <html> | ||
<iframe width=" | <iframe width="560" height="315" src="https://www.youtube.com/embed//BUdK9ec8nFk" frameborder="0" allowfullscreen></iframe> | ||
</html> | </html> | ||
''Not the same machine, but its setup the same way'' | |||
'''Also:''' | |||
[http://www.youtube.com/watch?v=5u4Efn1twUo&t=2m53s Start video at 2m53s] | [http://www.youtube.com/watch?v=5u4Efn1twUo&t=2m53s Start video at 2m53s] | ||
[http://www.youtube.com/watch?v=XoNZeBOV-10 Wiring the Plug] | |||
==Resources== | |||
*[http://www.youtube.com/watch?v=zAenbin4gRw Basic Principles of Plasma Cutting] | |||
*[http://www.youtube.com/watch?v=mJJydOxHwZU&feature=related Miller Plasma Animation] | |||
[[Category:CNC Torch Table]] | [[Category:CNC Torch Table]] | ||
[[Category:TIG]] | |||
[[Category:Plasma Cutting]] | |||
Latest revision as of 21:11, 17 October 2012
Overview
Use
Settings
Plasma Cutter Settings
- cut mode
- poles set at dc
- turn all green knobs to left except for the post flow
- pulse off
- 2t mode
- main amperage control - 50 or 60
- if we have the amperage control to 60 = we'll be drawing 50 amps
- ground clamp as close to the metal as possible
- maintain about 70 to 75 psi on the air compressor
- 4 cf/ minute on the air compressor
Plasma Cutting Tutorial
TIG Tutorial Videos
Not the same machine, but its setup the same way
Also: