D3D Lulzbot Cura: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 14: Line 14:


=Calibration=
=Calibration=
[[File:xymath.png]]


[http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide source]
From [[Triffid Hunter's Calibration Guide]]:
 
 
[[File:xymath.png]]

Revision as of 22:50, 9 June 2017

Introduction

Lulzbot Cura allows for ready setup of machines other than Lulzbot and Lulzbot Mini. As such, it is useful to use Lulzbot Cura for OSE's D3D 3D Printer.

By going to Expert-> Switch to Full Settings - you can set nozzle size and various parameters. Once all configuration has been input, you can save the profile as a .ini file.

To configure a new machine (bed size) go to the menu - Machine-> Add New Machine - you can add a profile for the D3D Original - 8" print bed.

Files

Configuration (.ini) file for D3D Lulzbot Cura:

File:D3DOriginal config.ini - D3D Original, 16" frame, 8" print bed, 0.5" nozzle.


Calibration

From Triffid Hunter's Calibration Guide:


Xymath.png