D3D v18.04 Software: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=Background= | =Background= | ||
There are 6 places where software may be configured when developing new versions of the OSE 3D Printer: | There are 6 places where software may be configured when developing new versions of the OSE 3D Printer: | ||
#'''Marlin''' - | #'''Marlin''' - versions after April 23, 2018 work - [[File:OSE_Marlin.zip]] | ||
#'''Configuration file (.ini) in Cura'''. | #'''Configuration file (.ini) in Cura'''. | ||
#'''Start and end g-codes in Cura''' - contained in configuration file | #'''Start and end g-codes in Cura''' - contained in configuration file | ||
Revision as of 21:59, 24 May 2018
Background
There are 6 places where software may be configured when developing new versions of the OSE 3D Printer:
- Marlin - versions after April 23, 2018 work - File:OSE Marlin.zip
- Configuration file (.ini) in Cura.
- Start and end g-codes in Cura - contained in configuration file
- Machine Settings in Cura - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament.
- Print parameters in Cura - contained in configuration file
To Get Proper Prints with a New Extruder
- Verify e-steps for the extruder - and make sure Cura machine settings are consistent.
- Test extruder - so it's extruding correctly with Cura interface
Software
Marlin
- D3D v18.04 Marlin is updated for a geared extruder - see - File:OSE Marlin.zip