D3D v18.04 Software: Difference between revisions
Jump to navigation
Jump to search
| Line 5: | Line 5: | ||
#'''Configuration file (.ini) in Cura''' - [[File:D3D Profile.ini]] | #'''Configuration file (.ini) in Cura''' - [[File:D3D Profile.ini]] | ||
#'''Start and end g-codes in Cura''' - contained in configuration file | #'''Start and end g-codes in Cura''' - contained in configuration file | ||
#'''Machine Settings in Cura''' - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament. | #'''Machine Settings in Cura''' - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament. '''This is the only place to set presence of heated bed.''' | ||
#'''Print parameters in Cura''' - contained in configuration file - | #'''Print parameters in Cura''' - contained in configuration file - | ||
Revision as of 22:30, 24 May 2018
Background
There are 5 places where software may be configured when developing new versions of the OSE 3D Printer. The Cura used here is D3D Lulzbot Cura.
- Marlin - versions after April 23, 2018 work - File:OSE Marlin.zip
- Configuration file (.ini) in Cura - File:D3D Profile.ini
- Start and end g-codes in Cura - contained in configuration file
- Machine Settings in Cura - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament. This is the only place to set presence of heated bed.
- Print parameters in Cura - contained in configuration file -
Notes
- Machine settings currently on OSE Linux v1.0 - heated bed needs to be turned on:
To Get Proper Prints with a New Extruder
- Verify e-steps for the extruder - and make sure Cura machine settings are consistent.
- Test extruder - so it's extruding correctly with Cura interface
Software
Marlin
- D3D v18.04 Marlin is updated for a geared extruder - see - File:OSE Marlin.zip